Skip to content
WattsBack

Trane S9V2 gas furnace error codes

Trane S9V2 gas furnace code E10: inducer not communicating

The S9V2's variable-speed inducer, the fan that pushes exhaust out, did not answer the control board. Without it the furnace cannot prove venting and will not light.

Photograph of a plain closed furnace cabinet with a metal duct in a tidy, softly lit basement
On this page
Code
E10
Equipment
Trane S9V2 gas furnace
Models
S9V2 two-stage condensing gas furnaces with variable-speed inducer
What to do
Technician repair

What code E10 means

Trane's Product Data - S9V2 Two Stage Condensing Gas Fired Furnace, incl. error code list (22-1938-1D-EN) lists E10 as inducer not communicating, for the S9V2 two-stage condensing gas furnaces with variable-speed inducer. A seven-segment display on the S9V2 control board shows a status word while the furnace runs, such as Lr1 or ArF, and an error code that starts with E when it finds a problem.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The inducer motor is not responding to the board.
  • Communication between the two small processors that run the system has failed.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  2. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E10 (the manual's first suspect is the inducer motor is not responding to the board). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Trane S9V2 gas furnace codes

The full Trane S9V2 gas furnace code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Trane, Product Data - S9V2 Two Stage Condensing Gas Fired Furnace, incl. error code list (22-1938-1D-EN) trane.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com