Air sealing checklist
Air sealing stops drafts that insulation does not. Find leaks, seal the reachable ones with caulk, weatherstripping and foam, and leave flue, vent and attic work to a professional. Sealing and ventilation go together.

On this page
The Department of Energy compares insulation to a sweater and air sealing to a windbreaker. A sweater slows heat but does not stop wind; a windbreaker does. A house with plenty of insulation can still lose heat if air moves through gaps, which is why sealing is often the cheapest improvement on a list.
Air sealing checklist
Insulation slows heat flow but doesn't stop air. DOE compares insulation to a sweater and air sealing to a windbreaker. This list covers what a homeowner can safely do and what to leave to a professional.
0 of 12 done
Find the leaks
Seal the obvious ones
DOE says do-it-yourself sealing works for obvious leaks and not for small hidden ones.
Leave these to a professional
After you seal
Sources (2)
Why it matters
DOE's consumer guide lists drafts, extra strain on heating and cooling equipment, higher bills, and moisture that can harm wood and encourage mold among the costs of leaks. In its Energy Saver Guide the department says sealing air leaks can cut heating and cooling bills by 10 to 20%. That is a range the department states for sealing in general, not a promise for a particular house.
What you can do yourself
DOE says a homeowner's own sealing works for obvious leaks, such as around door frames and where pipes, vents, wiring, ducts and fans go through exterior walls. The tool lists the usual methods from the Energy Saver Guide: weatherstripping doors and windows, caulking where pipes, ducts or wiring pass through walls, floors and ceilings, foam gaskets behind outlet and switch plates on exterior walls, and foam sealant for larger gaps. The consumer guide names acrylic latex caulk for general use.
What you should not do yourself
The same guide recommends a professional for anything around a flue, vent or pipe near a chimney, furnace or water heater, because those spots call for high-temperature materials. It also says to plan sealing together with ventilation, because combustion appliances without enough oxygen may release carbon monoxide. That is why two items on the list are flagged and why the page keeps its emergency box at the top. If a carbon monoxide alarm sounds after sealing, leave and call for help, as described in the box.
DOE also says that do-it-yourself sealing does not work well for small, hard-to-find leaks, especially in attics under insulation. Professionals use a blower door test or infrared imaging to find those.
Worked example
Hannah did the smoke test from the DIY audit checklist and found leaks at two window frames, the back door and the plumbing entry under the sink. She writes each one down with its size, buys weatherstripping, caulk and foam, and does those jobs. The attic hatch she weatherstrips. A gap where the water heater's vent pipe passes through the ceiling she leaves alone, because it is the kind of spot DOE says to hand to a professional. Before she begins she checks that the carbon monoxide alarms work, and afterward she repeats the smoke test and ticks off the leaks she fixed.
Renting
Small caulk and weatherstripping jobs are often fine, but read your lease and ask first if you are unsure. For bigger gaps, use the repair request letter.
Related
The winter bill reduction checklist and summer checklist cover the settings that go with a sealed house.