Skip to content
WattsBack

Furnace blower not working

If you smell gas or a carbon monoxide alarm sounds, leave and call for help. Otherwise say what the blower is doing and follow the checks that fit, from the thermostat fan setting to the filter, and call a technician for motors, switches and boards.

Photograph of a floor register in an oak floor under a still sheer curtain in morning light
On this page

The blower is the fan that pushes warm air from the furnace through your ducts. When it fails, the furnace can be burning fuel and the house still stays cold, or the fan can run all night without a reason. This page is for the homeowner whose furnace blower will not start, will not stop, or keeps starting and stopping, and it sorts the three cases so you only do the checks that fit.

Furnace blower not working

Start with the gas and carbon monoxide questions, then say what the blower is doing: not starting, never stopping, or starting and stopping. Each answer leads to the few checks that are safe for an owner and to the parts that belong to a technician.

Do you smell gas, or has a carbon monoxide alarm sounded or anyone felt sick?

I smell gas

Act now

Leave now and call for help

A gas smell near a furnace can mean a leak. A blower that will not run is not worth staying in the house for.

What to do

  1. Leave the home now with everyone in it, and keep pets with you if you can do that quickly.
  2. Do not turn lights or appliances on or off, use a lighter or match, or try to find the leak.
  3. From outside, call 911 and your gas utility's emergency number.
  4. Stay out until the utility or the fire department says it is safe.
A CO alarm sounded or someone feels sick

Act now

Get into fresh air and call emergency services now

A furnace that is not moving air properly can overheat and shut down, and a fuel-burning appliance that is not venting can release carbon monoxide.

What to do

  1. Get everyone, including pets, into fresh air now. Open the door on your way out.
  2. Call 911 from outside. Symptoms can look like the flu: headache, dizziness, weakness, nausea or confusion.
  3. Do not go back in to switch the appliance off. Wait for the fire department or a gas utility technician to say it is safe.
  4. Have the appliance inspected by a qualified technician before it runs again.
Neither

Any burning smell, smoke, sparking, or a breaker that keeps tripping?

Yes, one of those

Act now

Turn it off and call a licensed professional now

A burning smell, or a breaker that will not stay reset, points to a motor or electrical fault. A repeated fuse or breaker failure is on the manufacturer's call-for-service list.

What to do

  1. If you see smoke or flames, or the smell is strong, leave the home and call 911.
  2. Otherwise switch the equipment off at the thermostat and leave any breaker that tripped off. Do not keep resetting it.
  3. Call a licensed HVAC professional or electrician now. Do not open panels or touch wiring.
No

What is the blower doing?

Nothing, it will not start

Is the thermostat on heat with the target above the room, the furnace's own switch on, and the blower door panel fully seated?

Many furnaces cut power when the blower door is off or ajar. Switch the furnace's power off before you touch the panel.

One of those was wrong and I fixed it

Keep an eye on it

Give it a few minutes, then watch it

A thermostat on the wrong mode, a switch that was off or a panel that is not seated stops the blower from starting.

What to do

  1. Restore power, wait a few minutes and feel for air at a vent.
  2. If it does not start, come back and answer again.
  3. If it starts, then stops again within minutes, answer the starts-and-stops branch.
My stove and water heater are dead too

Deal with it soon

Call your gas utility

If other gas appliances are dead as well, the gas supply may be off or interrupted, which a furnace cannot run without.

What to do

  1. Call your gas utility and ask about service in your area.
  2. Do not touch any gas valve or connection yourself.
  3. If you smell gas at any time, leave and call for help from the start of this tree.
The breaker is tripped

Did you switch the breaker fully off and on once, and did it trip again or leave the furnace dead?

It tripped again, or the furnace is still dead

Act now

Stop resetting it and call a licensed professional now

A breaker that trips again means a fault in the furnace or its circuit.

What to do

  1. If you see smoke or flames, or the smell is strong, leave the home and call 911.
  2. Otherwise switch the equipment off at the thermostat and leave any breaker that tripped off. Do not keep resetting it.
  3. Call a licensed HVAC professional or electrician now. Do not open panels or touch wiring.
It held and the blower now starts

Keep an eye on it

Watch it, and book a check

A single trip can be a one-off, but it can also be an early sign of a worn motor or a failing part.

What to do

  1. Listen for new noises and check the filter, because a clogged one makes the motor work harder.
  2. If the breaker trips again, leave it off and call a licensed electrician or HVAC professional.
All of those are fine

Deal with it soon

Call a licensed HVAC technician

With the thermostat, switch, panel and breaker all fine, the cause is inside the furnace: a failed part, a lockout or a safety switch that tripped. None is a homeowner repair.

What to do

  1. Tell the technician what you checked and whether the thermostat display is working.
  2. Do not open the cabinet beyond the filter slot or work on wiring.
It runs and will not stop

Is the thermostat's fan setting on Auto, the filter clean and the return vents clear?

The fan was on, and I switched it to Auto

Keep an eye on it

Watch it through one heating cycle

A fan set to run all the time keeps the blower going between heating cycles. That is a setting, not a fault.

What to do

  1. Leave the fan on Auto and let the furnace finish a cycle.
  2. Expect the blower to run on for a short while after the burners stop. That is normal.
  3. If it still never stops, answer the branch again and choose the last answer.
The filter was dirty or a return was blocked, and I fixed it

Keep an eye on it

Restore airflow, then watch it

A dirty filter or blocked returns choke the airflow. The furnace overheats, a safety switch trips, and the blower can run on or cycle in response.

What to do

  1. Switch the furnace off, swap in a clean filter and move furniture or rugs from the return grilles and open the supply vents.
  2. Restore power and watch a full cycle.
  3. If the problem is still there, answer again and choose the technician result.
Those are fine and the blower still never stops

Deal with it soon

Call a licensed HVAC technician

A fan that never stops points to the thermostat, the fan limit switch, the motor or the control board. The last three are not homeowner repairs.

What to do

  1. If the thermostat uses batteries, replace them first. Do not take the thermostat off the wall or touch its wiring.
  2. Call a licensed HVAC technician and say the blower runs constantly.
  3. Switch the furnace off at its switch if you do not want it running while you wait.
It starts and stops over and over

Is the filter dirty or a return vent blocked?

Yes, and I fixed it

Keep an eye on it

Restore airflow, then watch it

A dirty filter or blocked returns choke the airflow. The furnace overheats, a safety switch trips, and the blower can run on or cycle in response.

What to do

  1. Switch the furnace off, swap in a clean filter and move furniture or rugs from the return grilles and open the supply vents.
  2. Restore power and watch a full cycle.
  3. If the problem is still there, answer again and choose the technician result.
No, both are fine

Deal with it soon

Call a licensed HVAC technician

Repeated starting and stopping with good airflow often traces to a dirty flame sensor, a limit switch or a clogged burner. Those are ignition and gas-side parts, not owner repairs.

What to do

  1. Write down how long each cycle lasts and any blinking light code on the furnace, if the manual lets you look without opening the cabinet.
  2. Do not clean the flame sensor or touch burners yourself.
  3. If you smell gas or soot at any time, go back to the start of this tree and leave.
It runs, but the air is cold

Keep an eye on it

Use the cold-air troubleshooter

A blower that runs but pushes out cool air is a different problem, usually the thermostat fan setting, airflow or the burners not staying lit.

What to do

  1. Open the furnace-blowing-cold-air tool and answer from the top.
  2. If you smell gas at any time, come back to the start of this tree: leave and call for help.

Why the safety questions come first

A furnace is a fuel-burning appliance. If the blower is not moving air across the heat exchanger, the furnace can overheat and shut itself down, and a blocked or failing furnace is one of the household sources of carbon monoxide named by both the CDC and the CPSC. So the tool opens by asking about a gas smell and about a carbon monoxide alarm or symptoms like headache, dizziness and nausea. Either answer ends the tool with an act-now result: get everyone out, then call 911 and, for gas, your utility. The next question covers burning smells, smoke, sparking and a breaker that keeps tripping, which also end in a call to a licensed professional.

The three blower problems

Trane describes the blower problem by symptom, and the tool follows that split.

It will not start. The cheap causes are a thermostat that is not set to heat, a switch that was turned off, a blower door panel that is not seated, a tripped breaker or a blown fuse, and a gas supply that is off. The tool asks about those in that order. A breaker that trips again after one reset is an act-now result, because a repeat means a fault.

It will not stop. The usual cause is a thermostat fan setting left on instead of Auto. A clogged filter or blocked return grilles can also keep the blower working. If none of that helps, the thermostat itself, the fan limit switch, the motor or the control board is to blame, and the last three are technician work.

It starts and stops again and again. Trane lists a dirty filter and blocked returns first, then a dirty flame sensor, a limit switch or a clogged burner. Those last three are ignition and gas-side parts, so the tool does not ask you to touch them.

What stays with a professional

Wiring, the fan limit switch, the capacitor, the blower motor, burners, flame sensors, the control board and any lockout are all on the manufacturer's not-DIY list. This page will not tell you to relight a pilot, open a gas line or bypass a safety switch. DOE advises weighing replacement once heating equipment is older than 15 years and repairs pile up.

Worked example

Dolores wakes to a silent house and a cold hallway, and the thermostat shows the furnace is calling for heat. No gas smell, no alarm, no burning smell. She picks "it will not start". The thermostat is on heat, but she remembers that her son changed the filter last week. When she looks, the blower door panel is slightly out of its slot, which cuts the furnace's power. She seats it, waits several minutes and feels warm air at a vent. Had the breaker been tripped, she would have reset it once and called a licensed pro if it tripped again.

If you rent

Report a dead blower to the property manager the same day, in writing, and keep a copy of the message. The renter's repair request letter gives you wording. Replacing a filter is usually fine for a tenant, but panels and parts are the landlord's responsibility.

If the blower runs but the air is cool, use furnace blowing cold air. For a furnace that will not light at all, use furnace not working. The furnace maintenance checklist lists the yearly upkeep that keeps blowers healthy.

Sources

  1. Trane, Furnace blower not working (help page) trane.com
  2. Carrier, Furnace not turning on (help page) carrier.com
  3. Centers for Disease Control and Prevention, About carbon monoxide cdc.gov
  4. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  5. U.S. Department of Energy, Consumer Guide to Home Heating and Cooling energy.gov