Skip to content
WattsBack

Recommended insulation R-values by climate zone

Find the attic and floor insulation level ENERGY STAR recommends for your climate zone when you retrofit an existing wood-framed home, and learn what to check before you buy insulation.

Photograph of an attic floor evenly filled with fluffy insulation between wooden joists in soft daylight
On this page

An under-insulated attic is one of the quiet reasons a house costs too much to heat and cool. This lookup shows how much insulation ENERGY STAR recommends adding to the attic and the floor of an existing wood-framed home in each climate zone, so you know the target before you talk to a contractor or price materials. It is meant for homeowners planning an upgrade and for anyone trying to judge whether the attic they have is the problem.

Recommended insulation for retrofitting existing wood-framed homes, by climate zone (ENERGY STAR, based on the 2021 IECC)
Climate zoneAttic, if uninsulatedAttic, if it already has three to four inchesFloor
1R30R25R13
2R49R38R13
3R49R38R19
4A and 4BR60R49R19
6, 5, and 4CR60R49R30
7 and 8R60R49R38

What R-value means

R-value measures how well insulation resists heat moving through it. A higher number means better resistance. The number belongs to the installed layer, so a thick layer of loose fill and a thin rigid board can reach the same R-value, and squashing a batt to fit lowers what it delivers. The table gives targets as R-values rather than inches for that reason.

How to read the table

Find your climate zone first. The zones run from the warmest, in the far south, to the coldest, in the far north and Alaska, and the letters split some zones by moisture. ENERGY STAR's page shows the zone map; your local building department can also tell you which zone you are in. The two attic columns cover the two situations ENERGY STAR plans for: an attic with no insulation at all, and one that already has a few inches. The floor column applies to floors over unheated spaces such as a crawlspace. ENERGY STAR says the levels are the cost-effective ones for each climate and that the guidance follows the residential provisions of the 2021 International Energy Conservation Code.

ENERGY STAR also covers walls and basements on the same page. When siding comes off an uninsulated wall, it recommends blowing insulation into the empty cavity and, in most zones, adding insulating sheathing under the new siding. Basement and crawlspace walls have their own targets. Those jobs are usually part of a larger project, so ask the contractor which code applies where you live.

Seal first, then insulate

The Department of Energy's air sealing guide makes a point worth remembering: air leaks are among the largest sources of energy loss in a home, and insulation does little to stop moving air. Seal the attic floor's gaps around pipes, wires, lights and the hatch before new insulation covers them up. The air sealing checklist walks through it, and DOE's Energy Saver Guide estimates that sealing can cut heating and cooling bills by 10 to 20%.

Checking what you have

From the attic hatch, look across the floor between the joists and note what kind of material is there and roughly how deep it is in a few spots. A photo of each spot helps when you ask for quotes. Wear a mask, gloves and long sleeves, step only on the joists, and do not touch wiring, light fixtures or any material you cannot identify. If you are unsure what is up there, a professional energy auditor or insulation contractor can measure it for you, and that visit is also the time to ask about the leaks the auditor finds.

Worked example

Grace lives in a zone near the middle of the map and her attic has only a thin layer of old batts. Her row says to bring an attic like hers, which already has some insulation, up to the existing-attic level for her zone, rather than the higher figure meant for a bare attic. Before buying anything she uses the DIY home energy audit checklist to find the leaks, has them sealed, and asks two contractors to quote the target R-value in writing.

Renters can use this page to make the case to a landlord, but adding insulation is the owner's decision.

Sources

  1. ENERGY STAR, Recommended Home Insulation R-Values energystar.gov
  2. U.S. Department of Energy, Consumer Guide to Air Sealing the Home energy.gov
  3. U.S. Department of Energy, Energy Saver Guide (2022) energy.gov