A.O. Smith gas water heater error codes
A.O. Smith gas water heater 8 flashes: power still present after shutoff
The knob was turned to OFF, yet the thermopile kept making power. Either it is cooling slower than expected or the pilot is still burning because its valve stuck open, which means gas is flowing when it should not be.

On this page
- Code
- 8 flashes
- Equipment
- A.O. Smith gas water heater
- Models
- Residential atmospheric gas water heaters with a status light gas control (75 and 100 gallon)
- What to do
- Turn it off and call a pro
What code 8 flashes means
A.O. Smith's Instruction Manual - Residential Gas Water Heaters, incl. status light codes (100276479) lists 8 flashes as power still present after shutoff, for the Residential atmospheric gas water heaters with a status light gas control (75 and 100 gallon). A small status light on the gas control, beside the temperature knob, flashes a count and repeats. One flash every three seconds is normal; other counts, a steady light or no light at all point to the pilot, the thermopile or the gas control.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The pilot valve in the gas control is stuck open, so the pilot keeps burning with the knob off.
- The thermopile is taking longer than normal to cool after the heater was shut off.
- If the code keeps returning after a cool down and relight, the gas control needs replacing.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 8 flashes (the manual's first suspect is the pilot valve in the gas control is stuck open, so the pilot keeps burning with the knob off). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related A.O. Smith codes
Other A.O. Smith gas water heater codes
The full A.O. Smith gas water heater code table lists every code with its meaning, and explains how to read and clear them.