Carrier 59SC5 gas furnace error codes
Carrier 59SC5 gas furnace code 45: control circuit lockout
The 59SC5 control board found an internal fault and locked out; unlike the newer control, this lockout clears itself after one hour. Switching the power off and on clears it; if the code returns, the board is replaced.

On this page
- Code
- 45
- Equipment
- Carrier 59SC5 gas furnace
- Models
- 59SC5A (59SC5) single-stage multipoise condensing gas furnaces
- What to do
- Technician repair
What code 45 means
Carrier's 59SC5 Single Stage 4-Way Multipoise Condensing Gas Furnace - Installation, Start-up, Operating and Service and Maintenance Instructions (59SC5A-11SI) lists 45 as control circuit lockout, for the 59SC5A (59SC5) single-stage multipoise condensing gas furnaces. An amber status light on the control board, seen through a small window in the blower door, flashes a two-digit code: the count of short flashes is the first digit and the count of long flashes is the second.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- A fault in the flame sensing circuit.
- A gas valve relay stuck open.
- A software check error on the board.
What you can safely check
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 45 (the manual's first suspect is a fault in the flame sensing circuit). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Carrier codes
Other Carrier 59SC5 gas furnace codes
The full Carrier 59SC5 gas furnace code table lists every code with its meaning, and explains how to read and clear them.