Rheem gas water heater error codes
Rheem gas water heater Six-one flashes: heater failed to light
The heater went through its lighting tries without proving a pilot flame and is now in lockout. The burner will not try again until the cause is fixed and the control is reset.

On this page
- Code
- Six-one flashes
- Equipment
- Rheem gas water heater
- Models
- 38, 40 and 50 gallon FVIR gas water heaters with flue damper and electronic control
- What to do
- Technician repair
What code Six-one flashes means
Rheem's Use & Care Manual: Residential Gas FVIR Water Heaters with Damper and Electronic Control (38, 40 and 50 gallon) lists Six-one flashes as heater failed to light, for the 38, 40 and 50 gallon FVIR gas water heaters with flue damper and electronic control. A small status light on the gas control (the box with the temperature dial) blinks a pattern, then pauses for about three seconds and repeats. Some codes are a single count; others are two counts, such as six blinks followed by one.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The pilot flame is unstable.
- The pilot tube is blocked or damaged.
- Carbon has built up on the pilot electrode.
- The pilot igniter wire is damaged.
- There is a problem with the gas supply.
What you can safely check
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Six-one flashes (the manual's first suspect is the pilot flame is unstable). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Rheem codes
Other Rheem gas water heater codes
- Short flash
- Heartbeat
- One flash
- Two flashes
- Three flashes
- Four flashes
- Five flashes
- Six-two flashes
- Six-three flashes
- Six-four flashes
- Seven flashes
- Eight-one flashes
- Eight-two flashes
- Eight-three flashes
- Eight-four flashes
The full Rheem gas water heater code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Rheem, Use & Care Manual: Residential Gas FVIR Water Heaters with Damper and Electronic Control (38, 40 and 50 gallon) res.cloudinary.com
- Carrier, Furnace not turning on (help page) carrier.com
- U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com