Skip to content
WattsBack

A.O. Smith power vent gas water heater error codes

A.O. Smith power vent gas water heater code 6: ignition failure, one hour lockout

The burner failed to light or hold a flame on all three tries. The gas control locks the heater out for one hour, or until the power is switched off and on.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
6
Equipment
A.O. Smith power vent gas water heater
Models
Residential power direct vent gas water heaters, 40, 50 and 75 gallon models
What to do
Technician repair

What code 6 means

A.O. Smith's Instruction Manual - Residential Gas Water Heaters, Power Direct Vented Models, incl. error codes (185884-001) lists 6 as ignition failure, one hour lockout, for the Residential power direct vent gas water heaters, 40, 50 and 75 gallon models. The gas control valve on the front of the tank signals a fault with its LED lights. The manual numbers the faults 1 to 16 and pictures the LED pattern for each one in its troubleshooting chart.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The gas supply is off or the gas pressure is too low.
  • The flame sensor is not sitting in a steady burner flame.
  • The flame sensor is dirty and needs cleaning.
  • The igniter plug or its socket on the gas control is loose or worn.
  • The igniter has failed.

What you can safely check

  1. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 6 (the manual's first suspect is the gas supply is off or the gas pressure is too low). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other A.O. Smith power vent gas water heater codes

The full A.O. Smith power vent gas water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. A.O. Smith, Instruction Manual - Residential Gas Water Heaters, Power Direct Vented Models, incl. error codes (185884-001) assets.aosmith.com
  2. Carrier, Furnace not turning on (help page) carrier.com
  3. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  4. Noritz, How to troubleshoot a tankless water heater noritz.com