Goodman modulating gas furnace error codes
Goodman modulating gas furnace code B9: low indoor airflow
The blower is delivering less air than the control is calling for, so the furnace runs at reduced output and may hold back from higher firing rates.

On this page
- Code
- B9
- Equipment
- Goodman modulating gas furnace
- Models
- GMVM97 and GCVM97 modulating (ComfortBridge control)
- What to do
- Often an owner fix
What code B9 means
Goodman's Service Instructions - Modulating Gas Furnaces (RS6612015R8) lists B9 as low indoor airflow, for the GMVM97 and GCVM97 modulating (ComfortBridge control). A row of three seven-segment LEDs on the ComfortBridge control board shows a letter and number code, such as E0 or B9. When the furnace is idle with no fault it shows IdL.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- Blocked filters, restrictive ductwork or undersized ductwork.
- Closed registers or blocked return grilles.
- A wrong motor or wrong model data for the furnace.
What you can safely check
- Check the air filter. A clogged filter starves the system of air and can make a furnace overheat and shut itself down. Turn the furnace off, slide the filter out and hold it to the light; replace it if light barely passes through.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code B9 (the manual's first suspect is blocked filters, restrictive ductwork or undersized ductwork). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Goodman codes
Other Goodman modulating gas furnace codes
The full Goodman modulating gas furnace code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Goodman, Service Instructions - Modulating Gas Furnaces (RS6612015R8) mobile.goodmanmfg.com
- Carrier, Furnace not turning on (help page) carrier.com
- ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com