Skip to content
WattsBack

Bradford White gas water heater error codes

Bradford White gas water heater Two flashes: flue damper circuit closed when it should be open

Before opening the flue damper, the control checks its safety circuit and found it already closed, as if the damper were stuck open. It will not light the burner, and it waits two minutes before trying the damper again.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
Two flashes
Equipment
Bradford White gas water heater
Models
Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control
What to do
Turn it off and call a pro

What code Two flashes means

Bradford White's Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) lists Two flashes as flue damper circuit closed when it should be open, for the Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control. A green light on the electronic gas control blinks a count, rests for three seconds, then repeats. Some codes are one count, such as four blinks; others are two groups, such as six blinks and then one.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The damper blade is stuck open or not in the right position.
  • The vent above the heater is blocked.
  • The damper itself is faulty.
  • A damper cord set is not fully plugged in, or the switch on the damper is not set to Automatic.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Two flashes (the manual's first suspect is the damper blade is stuck open or not in the right position). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Bradford White gas water heater codes

The full Bradford White gas water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Bradford White, Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) docs.bradfordwhite.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com