Skip to content
WattsBack

Bradford White gas water heater error codes

Bradford White gas water heater Eight-three flashes: gas control electronics fault

The gas control found a fault in its own electronics and stopped running the heater. The manual's first step is to cut and restore power to reset it; if that does not work, the control is replaced.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
Eight-three flashes
Equipment
Bradford White gas water heater
Models
Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control
What to do
Technician repair

What code Eight-three flashes means

Bradford White's Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) lists Eight-three flashes as gas control electronics fault, for the Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control. A green light on the electronic gas control blinks a count, rests for three seconds, then repeats. Some codes are one count, such as four blinks; others are two groups, such as six blinks and then one.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The control needs a reset by interrupting its power.
  • The control is wet or has been physically damaged.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  2. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Eight-three flashes (the manual's first suspect is the control needs a reset by interrupting its power). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Bradford White gas water heater codes

The full Bradford White gas water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Bradford White, Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) docs.bradfordwhite.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com