Bradford White gas water heater error codes
Bradford White gas water heater Three flashes: flue damper did not open fully
The control powered the flue damper open, but the damper safety circuit did not prove it reached the fully open position within 30 seconds. The burner stays off, and the control keeps retrying the damper every few minutes.

On this page
- Code
- Three flashes
- Equipment
- Bradford White gas water heater
- Models
- Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control
- What to do
- Turn it off and call a pro
What code Three flashes means
Bradford White's Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) lists Three flashes as flue damper did not open fully, for the Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control. A green light on the electronic gas control blinks a count, rests for three seconds, then repeats. Some codes are one count, such as four blinks; others are two groups, such as six blinks and then one.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The damper is out of position or is not swinging all the way open.
- The vent is obstructed.
- The damper has failed.
- A damper cord set is loose, or the damper switch is not on Automatic.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Three flashes (the manual's first suspect is the damper is out of position or is not swinging all the way open). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Bradford White codes
Other Bradford White gas water heater codes
- No flash
- One short flash
- Heartbeat
- Short flash once
- Two flashes
- Four flashes
- Five flashes
- Six-one flashes
- Six-two flashes
- Six-three flashes
- Six-four flashes
- Seven flashes
- Eight-one flashes
- Eight-two flashes
- Eight-three flashes
- Eight-four flashes
The full Bradford White gas water heater code table lists every code with its meaning, and explains how to read and clear them.