Bradford White gas water heater error codes
Bradford White gas water heater Six-three flashes: pilot flame went out
The pilot was lit but the flame was lost while the heater was running. The control tries to relight up to four times, then waits out a five minute lockout before starting again by itself.

On this page
- Code
- Six-three flashes
- Equipment
- Bradford White gas water heater
- Models
- Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control
- What to do
- Technician repair
What code Six-three flashes means
Bradford White's Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) lists Six-three flashes as pilot flame went out, for the Residential D Series flue damper gas water heaters (RG1D30T, RG1D40S) with ICON System control. A green light on the electronic gas control blinks a count, rests for three seconds, then repeats. Some codes are one count, such as four blinks; others are two groups, such as six blinks and then one.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The pilot flame is unsteady.
- The pilot tubing is kinked or blocked.
- Oxidation has built up on the pilot electrode.
- The pilot wiring is damaged or loose at the gas control.
- The heater is not getting enough combustion air.
- Gas pressure to the heater is too low.
What you can safely check
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Six-three flashes (the manual's first suspect is the pilot flame is unsteady). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Bradford White codes
Other Bradford White gas water heater codes
- No flash
- One short flash
- Heartbeat
- Short flash once
- Two flashes
- Three flashes
- Four flashes
- Five flashes
- Six-one flashes
- Six-two flashes
- Six-four flashes
- Seven flashes
- Eight-one flashes
- Eight-two flashes
- Eight-three flashes
- Eight-four flashes
The full Bradford White gas water heater code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Bradford White, Service Manual - Residential D Series Gas Water Heaters, incl. ICON status codes (238-51637-00) docs.bradfordwhite.com
- Carrier, Furnace not turning on (help page) carrier.com
- U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com