Goodman 80% gas furnace error codes
Goodman 80% gas furnace 7 flashes: low flame signal
The furnace still lights and heats, but the flame sensor current is low. The control flags it so the sensor and burner flame can be looked at before ignition starts to fail.

On this page
- Code
- 7 flashes
- Equipment
- Goodman 80% gas furnace
- Models
- GMES80, GCES80, AMES80 and ACES80 (PCBBF145 control board)
- What to do
- Technician repair
What code 7 flashes means
Goodman's Installation Instructions for *MES80 / *CES80 Gas Furnace (IOG-2021) lists 7 flashes as low flame signal, for the GMES80, GCES80, AMES80 and ACES80 (PCBBF145 control board). A red diagnostic LED on the control board blinks a number of times, pauses and repeats. A steady light means normal operation, rapid nonstop flashing means a polarity problem, and no light at all means no power.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The flame sensor is coated or oxidized.
- The flame sensor is not positioned properly in the flame.
- A lazy flame from wrong gas pressure or poor combustion air.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 7 flashes (the manual's first suspect is the flame sensor is coated or oxidized). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Goodman codes
Other Goodman 80% gas furnace codes
The full Goodman 80% gas furnace code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Goodman, Installation Instructions for *MES80 / *CES80 Gas Furnace (IOG-2021) mobile.goodmanmfg.com
- Noritz, How to troubleshoot a tankless water heater noritz.com
- Carrier, Furnace not turning on (help page) carrier.com
- U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov