Skip to content
WattsBack

Goodman 80% gas furnace error codes

Goodman 80% gas furnace 8 flashes: igniter circuit problem

The control found a fault in the igniter circuit, so the burners cannot light and the furnace does not run at all.

Photograph of a plain closed furnace cabinet with a metal duct in a tidy, softly lit basement
On this page
Code
8 flashes
Equipment
Goodman 80% gas furnace
Models
GMES80, GCES80, AMES80 and ACES80 (PCBBF145 control board)
What to do
Technician repair

What code 8 flashes means

Goodman's Installation Instructions for *MES80 / *CES80 Gas Furnace (IOG-2021) lists 8 flashes as igniter circuit problem, for the GMES80, GCES80, AMES80 and ACES80 (PCBBF145 control board). A red diagnostic LED on the control board blinks a number of times, pauses and repeats. A steady light means normal operation, rapid nonstop flashing means a polarity problem, and no light at all means no power.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The igniter is badly connected.
  • The igniter is bad; its resistance is out of spec.
  • Poor unit or burner ground.
  • A faulty control board.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  2. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 8 flashes (the manual's first suspect is the igniter is badly connected). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Goodman 80% gas furnace codes

The full Goodman 80% gas furnace code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Goodman, Installation Instructions for *MES80 / *CES80 Gas Furnace (IOG-2021) mobile.goodmanmfg.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com