Skip to content
WattsBack

Lennox gas furnace error codes

Lennox gas furnace code E205: gas valve relay shorted

The relay contact on the control that switches the gas valve is shorted, so the control cannot be sure it can shut the gas valve off. The furnace needs service before it runs again.

Photograph of a plain closed furnace cabinet with a metal duct in a tidy, softly lit basement
On this page
Code
E205
Equipment
Lennox gas furnace
Models
SL280UHNV and SL280DFNV (SL280V) and EL296DFV two-stage variable speed furnaces
What to do
Turn it off and call a pro

What code E205 means

Lennox's Installation Instructions SL280UHNV (507649-05, 04/2024) lists E205 as gas valve relay shorted, for the SL280UHNV and SL280DFNV (SL280V) and EL296DFV two-stage variable speed furnaces. A single seven-segment LED on the furnace's integrated control board spells out a status letter or an error code one character at a time, so code E250 shows as E, then 2, then 5, then 0.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • A wiring fault at the control or at the gas valve.
  • A failed relay on the control board, which means replacing the control if the wiring is correct.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E205 (the manual's first suspect is a wiring fault at the control or at the gas valve). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Lennox gas furnace codes

The full Lennox gas furnace code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Lennox, Installation Instructions SL280UHNV (507649-05, 04/2024) lennox.com
  2. Lennox, Installation Instructions SL280DFNV Dave Lennox Signature Gas Furnace (508150-02) lennox.com
  3. Lennox, Unit Information / Service Literature Corp 1126-L5 (revised 08/2022) lennox.com
  4. Noritz, How to troubleshoot a tankless water heater noritz.com