Skip to content
WattsBack

Lennox gas furnace error codes

Lennox gas furnace code E228: inducer calibration failed

The control could not complete its calibration of the combustion air inducer against the pressure switches, which it uses to set the draft. Heating waits until calibration succeeds.

Photograph of a plain closed furnace cabinet with a metal duct in a tidy, softly lit basement
On this page
Code
E228
Equipment
Lennox gas furnace
Models
SL280UHNV and SL280DFNV (SL280V) and EL296DFV two-stage variable speed furnaces
What to do
Turn it off and call a pro

What code E228 means

Lennox's Installation Instructions SL280UHNV (507649-05, 04/2024) lists E228 as inducer calibration failed, for the SL280UHNV and SL280DFNV (SL280V) and EL296DFV two-stage variable speed furnaces. A single seven-segment LED on the furnace's integrated control board spells out a status letter or an error code one character at a time, so code E250 shows as E, then 2, then 5, then 0.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • A problem in the vent system, such as a restriction.
  • Loose or wrong pressure switch wiring connections.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E228 (the manual's first suspect is a problem in the vent system, such as a restriction). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Lennox gas furnace codes

The full Lennox gas furnace code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Lennox, Installation Instructions SL280UHNV (507649-05, 04/2024) lennox.com
  2. Lennox, Installation Instructions SL280DFNV Dave Lennox Signature Gas Furnace (508150-02) lennox.com
  3. Lennox, Unit Information / Service Literature Corp 1126-L5 (revised 08/2022) lennox.com
  4. Noritz, How to troubleshoot a tankless water heater noritz.com