Skip to content
WattsBack

Navien combi boiler error codes

Navien combi boiler code E012: combi lost its flame

The NCB-E burner lit and then the flame signal dropped out, whether it was heating the house or tap water. The boiler shuts the gas and waits for a reset.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
E012
Equipment
Navien combi boiler
Models
NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E
What to do
Technician repair

What code E012 means

Navien's User's Information Manual - NCB-E Condensing Combi-Boilers lists E012 as combi lost its flame, for the NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E. The combi boiler shows an E and three digits on its front display while the error icon lights. In normal running the same display instead alternates between supply water temperature and system pressure.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • An air intake filter clogged with dust or lint, cutting the air the burner needs.
  • A boiler power cord that is not properly grounded.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  2. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E012 (the manual's first suspect is an air intake filter clogged with dust or lint, cutting the air the burner needs). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Navien combi boiler codes

The full Navien combi boiler code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Navien, User's Information Manual - NCB-E Condensing Combi-Boilers navieninc.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com
  3. Carrier, Furnace not turning on (help page) carrier.com
  4. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov