Navien combi boiler error codes
Navien combi boiler code E777: low water cutoff fault
The low water cutoff, a safety that stops the burner if the heating loop runs short of water, has acted or is reading wrong.

On this page
- Code
- E777
- Equipment
- Navien combi boiler
- Models
- NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E
- What to do
- Technician repair
What code E777 means
Navien's User's Information Manual - NCB-E Condensing Combi-Boilers lists E777 as low water cutoff fault, for the NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E. The combi boiler shows an E and three digits on its front display while the error icon lights. In normal running the same display instead alternates between supply water temperature and system pressure.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- Heating system water level too low, so make-up water must be added.
- A problem in the wiring to the low water cutoff.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E777 (the manual's first suspect is heating system water level too low, so make-up water must be added). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Navien codes
Other Navien combi boiler codes
- E003
- E004
- E012
- E016
- E030
- E046
- E047
- E060
- E109
- E110
- E205
- E218
- E351
- E352
- E353
- E407
- E421
- E439
- E515
- E517
- E594
- E615
- E736
- E740
- E782
The full Navien combi boiler code table lists every code with its meaning, and explains how to read and clear them.