Skip to content
WattsBack

Navien combi boiler error codes

Navien combi boiler code E110: combi air pressure fault

The NCB-E sensed air pressure in its combustion path outside the normal band, so it stops heating the house and the taps. Air is not moving freely in or out of the boiler, and a vent pipe that is broken or has come apart can let exhaust into the home, so in that case keep the boiler off and call a technician.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
E110
Equipment
Navien combi boiler
Models
NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E
What to do
Often an owner fix

What code E110 means

Navien's User's Information Manual - NCB-E Condensing Combi-Boilers lists E110 as combi air pressure fault, for the NCB-E condensing combi boilers: NCB-150E, 180E, 210E, 240E. The combi boiler shows an E and three digits on its front display while the error icon lights. In normal running the same display instead alternates between supply water temperature and system pressure.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • An exhaust pipe that is obstructed somewhere along its run.
  • An air intake filter loaded with dust or lint; Navien names this as a direct trigger and wants it cleaned every three to four months.

What you can safely check

  1. Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E110 (the manual's first suspect is an exhaust pipe that is obstructed somewhere along its run). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Navien combi boiler codes

The full Navien combi boiler code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Navien, User's Information Manual - NCB-E Condensing Combi-Boilers navieninc.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com