Skip to content
WattsBack

Navien tankless water heater error codes

Navien tankless water heater code E012: flame went out during use

The burner lit, but the flame sensor lost sight of the flame while hot water was running. The heater shuts the gas off and stops heating until the code is cleared.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
E012
Equipment
Navien tankless water heater
Models
NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2
What to do
Technician repair

What code E012 means

Navien's User's Information Manual - NPE Condensing Water Heaters lists E012 as flame went out during use, for the NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2. The code appears as an E followed by three digits on the front panel screen, beside the combustion and error icon. On units with the optional remote controller, the remote also shows the code and its status light turns red.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • A dusty or lint-clogged air intake filter that starves the burner of combustion air.
  • A power cord that is missing a proper ground.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  2. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E012 (the manual's first suspect is a dusty or lint-clogged air intake filter that starves the burner of combustion air). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Navien tankless water heater codes

The full Navien tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Navien, User's Information Manual - NPE Condensing Water Heaters navieninc.com
  2. Navien, Installation Manual - NPE Condensing Water Heaters (NPE-2) navieninc.com
  3. Noritz, How to troubleshoot a tankless water heater noritz.com
  4. Carrier, Furnace not turning on (help page) carrier.com
  5. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov