Skip to content
WattsBack

Navien tankless water heater error codes

Navien tankless water heater code E762: vent pipe not seated

A detector in the exhaust collar does not feel the vent pipe pushed in far enough, so the heater refuses to run. A loose exhaust pipe can leak flue gas, so leave the heater off until a technician refits it.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
E762
Equipment
Navien tankless water heater
Models
NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2
What to do
Turn it off and call a pro

What code E762 means

Navien's User's Information Manual - NPE Condensing Water Heaters lists E762 as vent pipe not seated, for the NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2. The code appears as an E followed by three digits on the front panel screen, beside the combustion and error icon. On units with the optional remote controller, the remote also shows the code and its status light turns red.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • An exhaust pipe that does not reach at least 2-3/4 inches into the collar on top of the heater.
  • A pipe of the wrong size, or one that is bent, out of line or has shifted up and down since installation.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E762 (the manual's first suspect is an exhaust pipe that does not reach at least 2-3/4 inches into the collar on top of the heater). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Navien tankless water heater codes

The full Navien tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Navien, User's Information Manual - NPE Condensing Water Heaters navieninc.com
  2. Navien, Installation Manual - NPE Condensing Water Heaters (NPE-2) navieninc.com
  3. Noritz, How to troubleshoot a tankless water heater noritz.com