Skip to content
WattsBack

Navien tankless water heater error codes

Navien tankless water heater code E110: air pressure out of range

The heater measured abnormal air pressure through the burner and vent, which usually means air cannot get in or exhaust cannot get out freely. It stops firing until the code is cleared. If any vent pipe looks cracked, loose or pulled apart, do not use the heater again until a technician has repaired it.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
E110
Equipment
Navien tankless water heater
Models
NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2
What to do
Often an owner fix

What code E110 means

Navien's User's Information Manual - NPE Condensing Water Heaters lists E110 as air pressure out of range, for the NPE-2 condensing series: NPE-180A2, 210A2, 240A2, 180S2, 210S2, 240S2. The code appears as an E followed by three digits on the front panel screen, beside the combustion and error icon. On units with the optional remote controller, the remote also shows the code and its status light turns red.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Something blocking the exhaust pipe, such as snow, ice, leaves or a nest at the outside opening.
  • An air intake filter clogged with dust or lint; Navien says this alone will stop the heater with this code.

What you can safely check

  1. Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E110 (the manual's first suspect is something blocking the exhaust pipe, such as snow, ice, leaves or a nest at the outside opening). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Navien tankless water heater codes

The full Navien tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Navien, User's Information Manual - NPE Condensing Water Heaters navieninc.com
  2. Navien, Installation Manual - NPE Condensing Water Heaters (NPE-2) navieninc.com
  3. Noritz, How to troubleshoot a tankless water heater noritz.com