Skip to content
WattsBack

Rheem heat pump water heater error codes

Rheem heat pump water heater code A008: dry fire protection

The control believes there is not enough water in the tank and disables heating so the elements do not burn out in air. It usually means the tank was not filled or air is still trapped in it.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
A008
Equipment
Rheem heat pump water heater
Models
Electric residential hybrid (heat pump) water heaters
What to do
Often an owner fix

What code A008 means

Rheem's Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) lists A008 as dry fire protection, for the Electric residential hybrid (heat pump) water heaters. Codes show as text on the top display, a letter and three digits such as A108 or T131. A warning icon lights and the heater beeps when a code is active.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The tank was not completely filled with water.
  • Air is trapped in the tank, usually after installation, and has not been bled out through a hot tap.

What you can safely check

  1. Check the water supply valves. Make sure the cold water valve to the heater is fully open and that the home has water pressure at other taps. A partly closed valve starves the heater of water.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A008 (the manual's first suspect is the tank was not completely filled with water). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rheem heat pump water heater codes

The full Rheem heat pump water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rheem, Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) media.rheem.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com