Skip to content
WattsBack

Rheem heat pump water heater error codes

Rheem heat pump water heater code T005: compressor shutdown from low airflow

The compressor outlet ran too hot because not enough air was moving over the coil, so the heat pump stops and the heater uses its electric elements instead. Hot water continues, at a higher running cost.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
T005
Equipment
Rheem heat pump water heater
Models
Electric residential hybrid (heat pump) water heaters
What to do
Often an owner fix

What code T005 means

Rheem's Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) lists T005 as compressor shutdown from low airflow, for the Electric residential hybrid (heat pump) water heaters. Codes show as text on the top display, a letter and three digits such as A108 or T131. A warning icon lights and the heater beeps when a code is active.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The fan is not running while the compressor is on.
  • The air filter screen on top is dirty and blocking airflow.
  • The compressor has failed or there are oily signs of a refrigerant leak.

What you can safely check

  1. Clean the heat pump's air filter. A hybrid water heater pulls room air through an air filter, and a clogged filter starves the heat pump of air. Your manual says how to clean it: some filters are washed with mild soap and water and left to dry, others are vacuumed or replaced.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code T005 (the manual's first suspect is the fan is not running while the compressor is on). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rheem heat pump water heater codes

The full Rheem heat pump water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rheem, Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) media.rheem.com
  2. Noritz, How to troubleshoot a tankless water heater noritz.com