Skip to content
WattsBack

Rheem heat pump water heater error codes

Rheem heat pump water heater code A107: water on the floor

The leak sensor, a rope that lies in the drain pan, is wet. The heater raises an alarm so you can look for a leak before it causes damage.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
A107
Equipment
Rheem heat pump water heater
Models
Electric residential hybrid (heat pump) water heaters
What to do
Often an owner fix

What code A107 means

Rheem's Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) lists A107 as water on the floor, for the Electric residential hybrid (heat pump) water heaters. Codes show as text on the top display, a letter and three digits such as A108 or T131. A warning icon lights and the heater beeps when a code is active.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Water is leaking from the heater or its piping into the pan.
  • The rope sensor is wet from an earlier spill and needs drying, or it has failed.
  • The control board is faulty if a new rope sensor does not clear the code.

What you can safely check

  1. Look at the condensate drain. Condensing equipment makes water that drains through a small hose or trap. A kinked hose, a full pump or water pooling under the unit can make it shut down. Straighten a kinked hose and empty a full pump reservoir; leave the trap itself to a technician.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A107 (the manual's first suspect is water is leaking from the heater or its piping into the pan). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rheem heat pump water heater codes

The full Rheem heat pump water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rheem, Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) media.rheem.com
  2. ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
  3. Noritz, How to troubleshoot a tankless water heater noritz.com