Rheem heat pump water heater error codes
Rheem heat pump water heater code A108: condensate line blocked
The condensate sensor found water backing up in the condensate pan, so the heat pump stops and the heater switches to its electric elements until the drain is clear.

On this page
- Code
- A108
- Equipment
- Rheem heat pump water heater
- Models
- Electric residential hybrid (heat pump) water heaters
- What to do
- Often an owner fix
What code A108 means
Rheem's Use & Care Manual With Installation Instructions for the Installer - Electric Residential Hybrid (alarm codes) lists A108 as condensate line blocked, for the Electric residential hybrid (heat pump) water heaters. Codes show as text on the top display, a letter and three digits such as A108 or T131. A warning icon lights and the heater beeps when a code is active.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The condensate line is blocked or kinked.
- Too much water is sitting in the condensate pan because of where the hose is routed.
- The condensate sensor is faulty, if the pan is dry and the line is clear.
What you can safely check
- Look at the condensate drain. Condensing equipment makes water that drains through a small hose or trap. A kinked hose, a full pump or water pooling under the unit can make it shut down. Straighten a kinked hose and empty a full pump reservoir; leave the trap itself to a technician.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A108 (the manual's first suspect is the condensate line is blocked or kinked). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Rheem codes
Other Rheem heat pump water heater codes
- A004
- A005
- T005
- A006
- T006
- A008
- T009
- A009
- A101
- A102
- A103
- A104
- A105
- A106
- A107
- A125
- A126
- A127
- A128
- A129
- A130
- T131
- T132
- A120
- A121
- A122
- A123
- A200
- T300
- A502
- A503
- T504
- A900
- T901
- A902
- A903
- A904
- A905
- A906
The full Rheem heat pump water heater code table lists every code with its meaning, and explains how to read and clear them.