Trane gas furnace error codes
Trane gas furnace code E09: inducer limit or condensate switch open
A switch near the inducer (the small exhaust fan) or the condensate switch, which watches for water backing up, has opened. The control keeps the burners off while it stays open.

On this page
- Code
- E09
- Equipment
- Trane gas furnace
- Models
- S9X2 two-stage condensing gas furnaces; also S8X2 two-stage 80% furnaces
- What to do
- Often an owner fix
What code E09 means
Trane's Product Data - S9X2 Two Stage Condensing Gas Fired Furnace, incl. error code list (22-1930-1G-EN) lists E09 as inducer limit or condensate switch open, for the S9X2 two-stage condensing gas furnaces; also S8X2 two-stage 80% furnaces. A small digital display on the integrated furnace control (IFC) shows a short status word, such as Ht1 while heating, and switches to a code starting with E when it finds a fault, for example E04 or E2.1.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The condensate switch opened, which happens when drain water is not flowing away.
- The inducer limit switch opened because the inducer area got too hot.
What you can safely check
- Look at the condensate drain. Condensing equipment makes water that drains through a small hose or trap. A kinked hose, a full pump or water pooling under the unit can make it shut down. Straighten a kinked hose and empty a full pump reservoir; leave the trap itself to a technician.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E09 (the manual's first suspect is the condensate switch opened, which happens when drain water is not flowing away). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Trane codes
Other Trane gas furnace codes
The full Trane gas furnace code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Trane, Product Data - S9X2 Two Stage Condensing Gas Fired Furnace, incl. error code list (22-1930-1G-EN) trane.com
- Trane, Product Data - S8X1/S8X2 80% Furnaces, incl. error code list (22-1644-1B-EN) elibrary.tranetechnologies.com
- ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com