Goodman heat pump error codes
Goodman heat pump code E12: control memory error
The outdoor control board reports a general memory error in its own electronics, and the outdoor unit may stop running until it clears.

On this page
- Code
- E12
- Equipment
- Goodman heat pump
- Models
- GSZV9 inverter heat pump (ComfortBridge)
- What to do
- Technician repair
What code E12 means
Goodman's *SZV9 Heat Pump Installation & Service Reference (IOG-4042) lists E12 as control memory error, for the GSZV9 inverter heat pump (ComfortBridge). A three-digit seven-segment display on the outdoor unit's control board shows the fault as E plus a number, such as E15. A communicating thermostat shows the same fault as a number with a short message.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- High electrical noise.
- A faulty control board.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code E12 (the manual's first suspect is high electrical noise). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Heat pump not heating troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Goodman codes
Other Goodman heat pump codes
- E13
- E15
- E17
- E18
- E19
- E20
- E21
- E22
- E23
- E24
- E25
- E26
- E27
- E28
- E29
- E30
- E31
- E32
- E34
- E35
- E36
- E37
- E38
- E39
- E40
- E41
- E42
- E43
- E44
- E45
- E46
- E47
- E48
- E49
- E50
- E51
- Eb0
- Eb9
- Ed0
- Ed1
- Ed2
- Ed3
- Ed4
The full Goodman heat pump code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Goodman, *SZV9 Heat Pump Installation & Service Reference (IOG-4042) mobile.goodmanmfg.com
- Noritz, How to troubleshoot a tankless water heater noritz.com