Goodman heat pump error codes
Goodman heat pump code Eb0: no indoor airflow
The indoor unit reports airflow close to zero, so the heat pump cannot move heat into the house. The outdoor unit flags the fault and will not run normally.

On this page
- Code
- Eb0
- Equipment
- Goodman heat pump
- Models
- GSZV9 inverter heat pump (ComfortBridge)
- What to do
- Technician repair
What code Eb0 means
Goodman's *SZV9 Heat Pump Installation & Service Reference (IOG-4042) lists Eb0 as no indoor airflow, for the GSZV9 inverter heat pump (ComfortBridge). A three-digit seven-segment display on the outdoor unit's control board shows the fault as E plus a number, such as E15. A communicating thermostat shows the same fault as a number with a short message.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- The indoor blower motor has failed.
- The indoor blower motor is not connected properly.
- Too much static pressure in the duct system.
What you can safely check
- Check the air filter. A clogged filter starves the system of air and can make a furnace overheat and shut itself down. Turn the furnace off, slide the filter out and hold it to the light; replace it if light barely passes through.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Eb0 (the manual's first suspect is the indoor blower motor has failed). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Heat pump not heating troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Goodman codes
Other Goodman heat pump codes
- E12
- E13
- E15
- E17
- E18
- E19
- E20
- E21
- E22
- E23
- E24
- E25
- E26
- E27
- E28
- E29
- E30
- E31
- E32
- E34
- E35
- E36
- E37
- E38
- E39
- E40
- E41
- E42
- E43
- E44
- E45
- E46
- E47
- E48
- E49
- E50
- E51
- Eb9
- Ed0
- Ed1
- Ed2
- Ed3
- Ed4
The full Goodman heat pump code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Goodman, *SZV9 Heat Pump Installation & Service Reference (IOG-4042) mobile.goodmanmfg.com
- Carrier, Furnace not turning on (help page) carrier.com
- ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com