Carrier gas furnace error codes
Carrier gas furnace code 21: voltage on the gas valve
Code 21.1: the control found 24 volts on the gas valve at a time when the valve should be off, and locked out gas heating. Power has to be off for five minutes before it will retry.

On this page
- Code
- 21
- Equipment
- Carrier gas furnace
- Models
- 59SC2E single-stage 35-inch condensing gas furnaces
- What to do
- Turn it off and call a pro
What code 21 means
Carrier's 59SC2E Single-Stage 35-in. Tall 4-Way Multipoise High Efficiency Condensing Gas Furnace - Installation, Start-up, Operating and Service and Maintenance Instructions (59SC2E-03SI) lists 21 as voltage on the gas valve, for the 59SC2E single-stage 35-inch condensing gas furnaces. A three-digit display on the control board shows codes such as 33.1, and the status light seen through the sight glass in the blower door flashes the first two digits as short and long flashes.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- A gas valve relay on the control board stuck closed.
- A miswired gas valve or a short on the gas valve wire.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 21 (the manual's first suspect is a gas valve relay on the control board stuck closed). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Carrier codes
Other Carrier gas furnace codes
The full Carrier gas furnace code table lists every code with its meaning, and explains how to read and clear them.