Carrier gas furnace error codes
Carrier gas furnace code 34: ignition or flame fault
The control is not seeing a steady flame: 34.1 means no flame was sensed during an ignition try, 34.2 that flame was lost before the blower came on, and 34.3 that it was lost after. Repeated failures lead to lockout 14.

On this page
- Code
- 34
- Equipment
- Carrier gas furnace
- Models
- 59SC2E single-stage 35-inch condensing gas furnaces
- What to do
- Technician repair
What code 34 means
Carrier's 59SC2E Single-Stage 35-in. Tall 4-Way Multipoise High Efficiency Condensing Gas Furnace - Installation, Start-up, Operating and Service and Maintenance Instructions (59SC2E-03SI) lists 34 as ignition or flame fault, for the 59SC2E single-stage 35-inch condensing gas furnaces. A three-digit display on the control board shows codes such as 33.1, and the status light seen through the sight glass in the blower door flashes the first two digits as short and long flashes.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- Low incoming gas pressure, or the manual gas shut-off valve closed.
- A dirty flame sensor giving a weak signal.
- Poor ground: the green and yellow wire must be fastened to the cabinet, and the sensor must not touch metal.
- A failed igniter or igniter wiring.
- A gas valve that does not open, or flame that does not carry over between burners.
What you can safely check
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 34 (the manual's first suspect is low incoming gas pressure, or the manual gas shut-off valve closed). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Carrier codes
Other Carrier gas furnace codes
The full Carrier gas furnace code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Carrier, 59SC2E Single-Stage 35-in. Tall 4-Way Multipoise High Efficiency Condensing Gas Furnace - Installation, Start-up, Operating and Service and Maintenance Instructions (59SC2E-03SI) shareddocs.com
- Carrier, Furnace not turning on (help page) carrier.com
- U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com