Goodman single-stage gas furnace error codes
Goodman single-stage gas furnace code EEb: gas valve not powered
The control should be sending power to the gas valve but sees none, so the burners cannot get gas and the furnace stops.

On this page
- Code
- EEb
- Equipment
- Goodman single-stage gas furnace
- Models
- GR9S92, GR9S96 and GD9S96; also GM9S92, GM9S96 and GC9S96
- What to do
- Turn it off and call a pro
What code EEb means
Goodman's Service and Troubleshooting - Single Stage Gas Furnaces and Accessories (RS6612301) lists EEb as gas valve not powered, for the GR9S92, GR9S96 and GD9S96; also GM9S92, GM9S96 and GC9S96. A three-character, seven-segment display on the furnace control board shows the code, read left to right, such as EE3 or E11. The display shows a status message instead when there is no fault.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- A wiring fault in the gas valve circuit.
- A failed control board.
What you can safely check
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code EEb (the manual's first suspect is a wiring fault in the gas valve circuit). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Furnace not working troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Goodman codes
Other Goodman single-stage gas furnace codes
The full Goodman single-stage gas furnace code table lists every code with its meaning, and explains how to read and clear them.