Rheem tankless water heater error codes
Rheem tankless water heater code A011: ignition failure
The heater tried to light 10 times, with a purge every third try, and the flame rod never saw a flame. It stops trying and shows A011 until the cause is found.

On this page
- Code
- A011
- Equipment
- Rheem tankless water heater
- Models
- IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i)
- What to do
- Technician repair
What code A011 means
Rheem's Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) lists A011 as ignition failure, for the IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i). The code appears as text on the LCD of the front user interface: a letter and three digits, such as A011 or T113. Codes starting with T are mostly notices; A codes are errors.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- Gas supply pressure is too low, or drops when another gas appliance runs.
- The gas filter at the gas inlet is clogged.
- The air filter at the air inlet is blocked.
- A vent pipe is disconnected or the inlet or exhaust termination is blocked.
- The igniter rod, igniter coil or a loose connection is stopping the spark.
- The flame rod is dirty or failing, or the gas-air ratio valve or gas solenoid valve has failed.
What you can safely check
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
- Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A011 (the manual's first suspect is gas supply pressure is too low, or drops when another gas appliance runs). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Rheem codes
Other Rheem tankless water heater codes
- A012
- A014
- A018
- A029
- A031
- A032
- A033
- A035
- A036
- A055
- A061
- A063
- A065
- A066
- A070
- A071
- A072
- A082
- A090
- A200
- A2##
- T110
- T111
- T113
- T115
- T116
The full Rheem tankless water heater code table lists every code with its meaning, and explains how to read and clear them.