Skip to content
WattsBack

Rheem tankless water heater error codes

Rheem tankless water heater code A014: overheat limiter tripped

One of the two overheat safeties, the limiter or the limit fuse, has opened and the heater stops firing. Rheem says this usually comes from a gas supply or venting problem.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
A014
Equipment
Rheem tankless water heater
Models
IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i)
What to do
Turn it off and call a pro

What code A014 means

Rheem's Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) lists A014 as overheat limiter tripped, for the IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i). The code appears as text on the LCD of the front user interface: a letter and three digits, such as A011 or T113. Codes starting with T are mostly notices; A codes are errors.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The gas supply is inadequate or wrong for the heater.
  • The venting is inadequate, blocked or wrongly installed.
  • A loose connection at the control board or the limiter plug.
  • The overheat limiter or limit fuse has failed, in which case the unit is replaced.

What you can safely check

  1. Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
  2. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  3. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A014 (the manual's first suspect is the gas supply is inadequate or wrong for the heater). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rheem tankless water heater codes

The full Rheem tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rheem, Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) res.cloudinary.com
  2. Carrier, Furnace not turning on (help page) carrier.com
  3. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  4. Noritz, How to troubleshoot a tankless water heater noritz.com