Rheem tankless water heater error codes
Rheem tankless water heater code T113: flow too low to fire
Water is moving through the heater at less than 0.4 gallons per minute, which is below the minimum it needs, so the burner will not come on.

On this page
- Code
- T113
- Equipment
- Rheem tankless water heater
- Models
- IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i)
- What to do
- Often an owner fix
What code T113 means
Rheem's Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) lists T113 as flow too low to fire, for the IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i). The code appears as text on the LCD of the front user interface: a letter and three digits, such as A011 or T113. Codes starting with T are mostly notices; A codes are errors.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- Faucet aerators or shower heads are clogged, or one fixture alone does not draw enough flow.
- The in-line water filter is dirty.
- The hot and cold supply lines are connected to the wrong ports.
- Scale is restricting the water passages and the heater needs flushing.
- The flow sensor in the water control valve is blocked.
- A plumbing crossover in the house is mixing cold water into the hot lines.
What you can safely check
- Run a hot tap harder. Tankless heaters only fire above a minimum flow. Open a hot tap fully, and clean a clogged faucet aerator or shower head, before deciding the heater is at fault.
- Clean the cold water inlet filter. Tankless heaters and combi boilers have a small screen where cold water enters. Debris on it lowers flow and can stop the burner lighting. The manual shows how to clean it: power off, water valves closed, then remove the screen and rinse it.
- Check the water supply valves. Make sure the cold water valve to the heater is fully open and that the home has water pressure at other taps. A partly closed valve starves the heater of water.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code T113 (the manual's first suspect is faucet aerators or shower heads are clogged, or one fixture alone does not draw enough flow). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Rheem codes
Other Rheem tankless water heater codes
- A011
- A012
- A014
- A018
- A029
- A031
- A032
- A033
- A035
- A036
- A055
- A061
- A063
- A065
- A066
- A070
- A071
- A072
- A082
- A090
- A200
- A2##
- T110
- T111
- T115
- T116
The full Rheem tankless water heater code table lists every code with its meaning, and explains how to read and clear them.