Skip to content
WattsBack

Rheem tankless water heater error codes

Rheem tankless water heater code A012: flame lost repeatedly

The burner lit but the flame went out during firing. Each time, the heater cuts the gas and tries again, and after 15 losses in a row it stops and shows A012.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
A012
Equipment
Rheem tankless water heater
Models
IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i)
What to do
Technician repair

What code A012 means

Rheem's Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) lists A012 as flame lost repeatedly, for the IKONIC RTGH-S, RUTGH-S, CRTGH-S and CRUTGH-S (S and SR, 84i, 10i, 11i). The code appears as text on the LCD of the front user interface: a letter and three digits, such as A011 or T113. Codes starting with T are mostly notices; A codes are errors.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Gas supply pressure is too low, especially while other gas appliances run.
  • The gas filter at the gas connection is clogged.
  • The air filter at the air inlet is blocked.
  • The vent is disconnected or its termination is blocked.
  • The flame rod needs cleaning or replacing.
  • The gas-air ratio valve or the gas solenoid valve has failed.

What you can safely check

  1. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  2. Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
  3. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  4. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code A012 (the manual's first suspect is gas supply pressure is too low, especially while other gas appliances run). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rheem tankless water heater codes

The full Rheem tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rheem, Technical Training and Service Manual - Tankless Water Heaters (RTGH-S) res.cloudinary.com
  2. Carrier, Furnace not turning on (help page) carrier.com
  3. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  4. Noritz, How to troubleshoot a tankless water heater noritz.com