Skip to content
WattsBack

A.O. Smith heat pump water heater error codes

A.O. Smith heat pump water heater code Condensate Drain Alarm: condensate pump failure

The float switch in an added condensate pump opened because the pump is not clearing water. The control shuts off the heat pump so it stops making condensate, and the front display shows a heat pump fault.

Photograph of a plain white tank water heater with copper pipes in a tidy utility closet
On this page
Code
Condensate Drain Alarm
Equipment
A.O. Smith heat pump water heater
Models
PHPT-60 and PHPT-80 hybrid electric heat pump water heaters
What to do
Often an owner fix

What code Condensate Drain Alarm means

A.O. Smith's Service Handbook - Residential Hybrid Electric Heat Pump Water Heater, incl. fault codes (321547-000) lists Condensate Drain Alarm as condensate pump failure, for the PHPT-60 and PHPT-80 hybrid electric heat pump water heaters. Faults show as a text message on the touch display on the front of the heater. The exact fault name is kept in a maintenance screen as codes E01 to E04, newest first.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The condensate pump is unplugged or its outlet, breaker, fuse or GFCI has no power.
  • The condensate pump has failed.
  • The pump's drain tube is kinked or blocked.
  • A loose or damaged wire in the pump failure detect circuit.

What you can safely check

  1. Look at the condensate drain. Condensing equipment makes water that drains through a small hose or trap. A kinked hose, a full pump or water pooling under the unit can make it shut down. Straighten a kinked hose and empty a full pump reservoir; leave the trap itself to a technician.
  2. Check the breaker. Look for a tripped breaker in the electrical panel and reset it once. If it trips again, leave it off and call a technician: a breaker that keeps tripping is a fault, not a nuisance.
  3. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code Condensate Drain Alarm (the manual's first suspect is the condensate pump is unplugged or its outlet, breaker, fuse or GFCI has no power). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other A.O. Smith heat pump water heater codes

The full A.O. Smith heat pump water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. A.O. Smith, Service Handbook - Residential Hybrid Electric Heat Pump Water Heater, incl. fault codes (321547-000) assets.aosmith.com
  2. ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
  3. Carrier, Furnace not turning on (help page) carrier.com
  4. Sears Home Services, Water heater problems and troubleshooting searshomeservices.com
  5. Noritz, How to troubleshoot a tankless water heater noritz.com