Rinnai tankless water heater error codes
Rinnai tankless water heater code 02: burner will not fire during freeze protection
On non-SENSEI models, the heater tried to fire its burner to protect itself from freezing but could not get it lit. Without that burner the unit relies on its electric freeze protection alone.

On this page
- Code
- 02
- Equipment
- Rinnai tankless water heater
- Models
- SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
- What to do
- Technician repair
What code 02 means
Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 02 as burner will not fire during freeze protection, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.
What usually causes it
The manual points to these causes for this code, roughly in the order a technician would rule them out:
- A gas valve is closed, or gas pressure to the heater is too low.
- Air was left in the gas line after installation.
- The gas supplied does not match the heater, or the gas type switch is set wrong.
- The igniter is not sparking, or the electrode and flame rod are loose or dirty.
- Venting or condensate drain problems, or moisture in the wiring, are upsetting combustion.
What you can safely check
- Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
- Check for freezing. In a cold garage, attic or outside wall, pipes and the heater itself can freeze. If it is below freezing where the unit sits, keep power on (freeze protection only works while the unit has power) and call a technician before running water if you suspect a frozen or split pipe.
- Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
When to call a technician
Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 02 (the manual's first suspect is a gas valve is closed, or gas pressure to the heater is too low). That saves a diagnostic visit from starting at zero.
Step by step for this kind of problem
The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.
Related Rinnai codes
Other Rinnai tankless water heater codes
The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.
Sources
- Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
- Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
- Carrier, Furnace not turning on (help page) carrier.com
- U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
- Noritz, How to troubleshoot a tankless water heater noritz.com