Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 11: no ignition

Hot water was called for, but the burner never lit. The heater stops trying and shows the code, so no hot water is made until the cause is fixed.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
11
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Technician repair

What code 11 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 11 as no ignition, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • A gas valve on the supply is closed, or a propane tank is empty.
  • Air is still in the gas line after installation.
  • Gas pressure is too low, often because the gas line, meter or regulator is too small.
  • The gas type does not match the heater or its gas setting.
  • The igniter is not sparking, or the electrode or flame rod is loose or coated with carbon.
  • Venting faults or moisture in the wiring are affecting ignition.

What you can safely check

  1. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.
  3. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 11 (the manual's first suspect is a gas valve on the supply is closed, or a propane tank is empty). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Carrier, Furnace not turning on (help page) carrier.com
  4. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  5. Noritz, How to troubleshoot a tankless water heater noritz.com