Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 07: circulation flow too low (rh180)

On the RH180 hybrid tank-tankless heater, water is circulating through the unit at less than 2.1 gallons per minute, too little for it to work properly, so it flags the low flow.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
07
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Often an owner fix

What code 07 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 07 as circulation flow too low (rh180), for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The heater has no power.
  • The water supply is off or below 30 PSI.
  • The circulation pump is not running or its wiring is loose.
  • The inlet water filter is clogged.
  • Scale is clogging the heat exchanger and it needs a flush.

What you can safely check

  1. Check the water supply valves. Make sure the cold water valve to the heater is fully open and that the home has water pressure at other taps. A partly closed valve starves the heater of water.
  2. Clean the cold water inlet filter. Tankless heaters and combi boilers have a small screen where cold water enters. Debris on it lowers flow and can stop the burner lighting. The manual shows how to clean it: power off, water valves closed, then remove the screen and rinse it.
  3. Check the power switch. Furnaces, boilers and powered water heaters have a service switch on or near the unit. Make sure it is on, and that the unit is plugged in if it has a cord.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 07 (the manual's first suspect is the heater has no power). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Noritz, How to troubleshoot a tankless water heater noritz.com
  4. Carrier, Furnace not turning on (help page) carrier.com