Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code LC: scale buildup in the heat exchanger

LC, or LC0 to LC9, means mineral scale is clogging the heat exchanger, which should be flushed out before it is damaged. On newer models the code locks the heater out; a temporary reset gives about 70 hours of use at a time.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
LC
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Often an owner fix

What code LC means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists LC as scale buildup in the heat exchanger, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Hard water has left scale inside the heat exchanger.
  • The heat exchanger has not been flushed on schedule, and the water may need treatment to stop scale coming back.

What you can safely check

  1. Reset it once. Turn the unit off at its switch, wait a minute, and turn it back on, or use the reset the manual describes. One reset clears a passing glitch. If the same code comes back, stop resetting and book a technician.
  2. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code LC (the manual's first suspect is hard water has left scale inside the heat exchanger). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Noritz, How to troubleshoot a tankless water heater noritz.com