Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 63: recirculation flow too low

The heater's recirculation system is not getting enough water moving through its loop, so it flags low flow. Air in the pipes, closed valves and settings that do not match the plumbing are the main reasons the guide gives.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
63
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Often an owner fix

What code 63 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 63 as recirculation flow too low, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Recirculation settings do not match the system, or the pump setting is on with no pump connected.
  • The inlet or bypass filter is clogged, or the bypass plug and filter are in the wrong places.
  • The cold inlet or hot outlet valve at the heater is closed.
  • Air is trapped in the recirculation line, often drawn in by a leak in the home's plumbing.
  • The pump is not getting 120 volts, or the loop is longer than allowed.

What you can safely check

  1. Check the water supply valves. Make sure the cold water valve to the heater is fully open and that the home has water pressure at other taps. A partly closed valve starves the heater of water.
  2. Clean the cold water inlet filter. Tankless heaters and combi boilers have a small screen where cold water enters. Debris on it lowers flow and can stop the burner lighting. The manual shows how to clean it: power off, water valves closed, then remove the screen and rinse it.
  3. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 63 (the manual's first suspect is recirculation settings do not match the system, or the pump setting is on with no pump connected). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Noritz, How to troubleshoot a tankless water heater noritz.com