Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 25: condensate pump or drain problem

Condensate backed up far enough to trip the float safety switch, or the add-on condensate pump stopped working. The heater shuts down to avoid spilling water.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
25
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Often an owner fix

What code 25 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 25 as condensate pump or drain problem, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The condensate pump has no power or has stopped working.
  • The drain line is clogged or frozen.
  • Wiring between the pump or trap and the circuit board is loose or damaged.
  • The drain line has no air gap, or the condensate trap is restricted.

What you can safely check

  1. Look at the condensate drain. Condensing equipment makes water that drains through a small hose or trap. A kinked hose, a full pump or water pooling under the unit can make it shut down. Straighten a kinked hose and empty a full pump reservoir; leave the trap itself to a technician.
  2. Check the power switch. Furnaces, boilers and powered water heaters have a service switch on or near the unit. Make sure it is on, and that the unit is plugged in if it has a cord.
  3. Check for freezing. In a cold garage, attic or outside wall, pipes and the heater itself can freeze. If it is below freezing where the unit sits, keep power on (freeze protection only works while the unit has power) and call a technician before running water if you suspect a frozen or split pipe.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 25 (the manual's first suspect is the condensate pump has no power or has stopped working). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. ENERGY STAR, Maintenance Checklist (heating and cooling) energystar.gov
  4. Carrier, Furnace not turning on (help page) carrier.com
  5. Noritz, How to troubleshoot a tankless water heater noritz.com