Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 12: flame failure

The burner lit but the flame was lost, or the flame rod stopped sensing it. The heater shuts the gas off and shows the code instead of keeping on trying.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
12
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Technician repair

What code 12 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 12 as flame failure, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • Gas is turned off at the heater, the meter or the propane tank, or the tank is empty.
  • Inlet gas pressure is low because the gas system is undersized.
  • Exhaust is being drawn back in because vent joints, length or terminal clearances are wrong.
  • The flame rod or electrode is loose, or its wiring or protective sleeve is damaged.
  • The electrical ground is poor, or a short in a component trips the code right after water starts to flow.
  • Insects or debris are in the fan, or the gas valve is not opening properly.

What you can safely check

  1. Check that gas is reaching the house. If other gas appliances (stove, dryer) also do not work, the problem is the gas supply, so call your gas utility. Do not try to light anything or adjust the gas valve yourself.
  2. Look at the vent pipes outside. High-efficiency furnaces, boilers and tankless heaters breathe through plastic pipes on an outside wall or the roof. From the ground, check that snow, ice, leaves or a nest are not blocking either opening, and clear what you can reach safely.
  3. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 12 (the manual's first suspect is gas is turned off at the heater, the meter or the propane tank, or the tank is empty). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Carrier, Furnace not turning on (help page) carrier.com
  4. U.S. Consumer Product Safety Commission, Carbon Monoxide Information Center cpsc.gov
  5. Noritz, How to troubleshoot a tankless water heater noritz.com