Skip to content
WattsBack

Rinnai tankless water heater error codes

Rinnai tankless water heater code 52: gas valve signal fault

The control found a problem with the gas valve or its modulating solenoid, the coil that varies gas flow to match demand. The heater stops until a technician repairs or replaces the valve.

Photograph of a plain white wall-mounted tankless water heater with insulated pipes below it
On this page
Code
52
Equipment
Rinnai tankless water heater
Models
SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180
What to do
Turn it off and call a pro

What code 52 means

Rinnai's Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) lists 52 as gas valve signal fault, for the SENSEI and non-SENSEI tankless: RU, RUR, RUC, RE, RX, CX, RL, V series (incl. V53De), RH180. The code flashes as two digits or two letters on the temperature controller or the heater's front display, for example 11, 12 or LC. It stops flashing once the problem is fixed and the heater is supplying hot water again.

What usually causes it

The manual points to these causes for this code, roughly in the order a technician would rule them out:

  • The flame rod or its wiring is loose or damaged.
  • The gas valve solenoid wiring has loose or damaged terminals.
  • The solenoid coil is open or reads outside its range.
  • The gas valve or the PC board has failed.

What you can safely check

  1. Write the code down before you reset. Many controls forget the code once power is cut. Note it, how often it flashes, and when it happens. A technician can then go straight to the right part.

When to call a technician

Call if the code returns after one reset, if you saw or smelled anything unusual, or as soon as a check above points at a part inside the unit. Tell the technician the brand, the model number from the rating label, and that the control showed code 52 (the manual's first suspect is the flame rod or its wiring is loose or damaged). That saves a diagnostic visit from starting at zero.

Step by step for this kind of problem

The Tankless water heater, no hot water troubleshooter walks through the symptom question by question and ends with a clear next step.

Other Rinnai tankless water heater codes

The full Rinnai tankless water heater code table lists every code with its meaning, and explains how to read and clear them.

Sources

  1. Rinnai, Troubleshooting Tankless Water Heater Diagnostic Codes (100000652) media.rinnai.us
  2. Rinnai, V53De Installation and Operation Manual, incl. diagnostic codes (100000561) media.rinnai.us
  3. Noritz, How to troubleshoot a tankless water heater noritz.com